The RATS Software Forum

Posted: **Wed Jan 29, 2025 8:42 am**

Dear Tom,
I couldn't compute the partial sums of series for each unit in the panel data set. When I run the accumulate instruction, the prog accumulates partial sums for the entire series but not for each cross-section unit. How can I fix it. Please help! Pleae find the prog attached. I will appreciate your responce.

PNARDL.rpf: (1007 Bytes) Downloaded 559 times

Posted: **Thu Jan 30, 2025 12:32 pm**

This will do the same thing as ACCUMULATE within each panel individual.

Code: Select all

dec real total
set ly_p 1//1992:1 6//2023:1 = total=%if(%indiv(t)<>%indiv(t-1),0.0,total),$
     %if(%valid(dly_p),total=total+dly_p,%na)

Posted: **Fri Jan 31, 2025 7:37 am**

Thank You very much!

The RATS Software Forum

Panel Partial accumulation for each unit

Panel Partial accumulation for each unit

Re: Panel Partial accumulation for each unit

Re: Panel Partial accumulation for each unit