cutting samples
Posted: Wed Dec 15, 2010 7:33 pm
Hi there
I was trying to cut some subperiods of my data, say i have 1000 data points of two series aa and bb, and I only want to use the second half of them :
but the data I actually get is only the first half of the data.
I've read the manual it said one can set the start and end under instruction "data"
but it just dont work here. How come?
by the way, I tried to use smpl as well, such as:
the program still runs on the full sample to do the whole sample estimation, only supply a window (500-1000) of results.
how should I do it? Thanks
I was trying to cut some subperiods of my data, say i have 1000 data points of two series aa and bb, and I only want to use the second half of them :
Code: Select all
open data d:\a.rat
data(fromat=rat,org=col) 500 1000 aa bb
I've read the manual it said one can set the start and end under instruction "data"
but it just dont work here. How come?
by the way, I tried to use smpl as well, such as:
Code: Select all
open data d:\a.rat
data(fromat=rat,org=col) / aa bb
smpl 500 1000
com.....
how should I do it? Thanks