Graph Format

[AhmedSahlool]

Dear Tom,

I hope this finds you well,

Would you kindly tell me how to change the format of graphs generated by procedures like @MCGraphIRF. I would like to increase the font of vertical axis figures.

Thank you and best regards.

[TomDoan]

Then change them. The following is in the procedure:

grparm(bold) hlabel 18 matrixlabels 14
grparm axislabel 24

Those are all relative to the size of the graph. If you find one too small, increase it.

[AhmedSahlool]

Thank you for your reply.

And for the titles of the graphs, I would like to increase their size, they remain unchanged, when i change these parameters.

Thank you

[TomDoan]

The header? You can add a change to the HEADER to the first of the two GRPARM's. The default is 24.

[AhmedSahlool]

Dear Tom,

Yes, it's not what convenient to resort to one graph per page, but what could I do if I have graphs that I can't present in a word document, I tried to modify the options in the procedure @MCGraphIRF, but I still have graphs that I can't read one I copy to word, see attached.

I ended with grparm(bold) hlabel 60 matrixlabels 18
grparm axislabel 34
*
Would you give me some hints.

Thank you very much

[TomDoan]

I suggested that you change the size of HEADER, not HLABEL. There are no HLABEL's in that graph.

[AhmedSahlool]

Thank you.

and what about the lines of the graphs, how could I change their format?

[TomDoan]

See section 3.16 of the RATS Introduction.